Table of Contents
Advertisement
▪
Status changes of the unit can be recorded in an
internal log file.
▪
The log file is configured on the GENERAL settings
page.
In order to be able to evaluate the log file, the
▪
Logfile Viewer, which is part of the PC software,
can be used.
Open the Logfile Viewer via Menu > Logfile
▪
Viewer.
The individual events are displayed line by line in
▪
the table on the left.
DATE: The date on which the event was recorded.
▪
The correct date is only displayed if the unit has a
connection to an NTP server.
▪
TIME (LOCAL): The time at which the event was
recorded. The correct time is only displayed if the
unit has a connection to an NTP server. The time is
converted to the time zone of the PC by the PC
software.
Logfile Viewer (2)
DURATION [d] hh:mm:ss,msec: Duration for which
▪
the event was active in hours : minutes : seconds ,
milliseconds. This information is only available if it is
relevant.
▪
TYPE: A short information about the type of event.
▪
SOURCE: Source of the event, e.g., Channel, LAN.
STATUS: Shows the new state of the component.
▪
▪
OK: An alarm is reset.
▪
ERROR: An alarm has occurred.
SET / CLEARED: TTL status
▪
LAN mode (speed / duplex)
▪
DESCRIPTION: A short text describing the event in
▪
more detail or providing additional information.
▪
FILTER: The list of events can be filtered. Check
the boxes of the categories which should be
displayed.
▪
SET FILTER: The new filter settings are not applied
to the table until the SET FILTER key has been
pressed.
Advertisement
Table of Contents
