Table of Contents
Advertisement
▪
In the IP LEASED LINE DIAL STANDARD mode,
audio is transmitted directly between two
devices.
▪
This mode is compatible with MAGIC AC1 XIP and
MAGIC ACip3.
A connection can be established automatically
▪
after power-up or using the Connect buttons.
LABEL: Enter any text. The label is displayed in
▪
the main panel of the PC software above the
channel.
REMOTE IP ADDRESS: IP address of the remote
▪
device. The encoded data is sent to this address.
Incoming data packets are only accepted from
this address.
AUDIO UDP PORT: UDP port used for sending and
▪
receiving audio data.
AUDIO VLAN: Select which VLAN is used for the
▪
audio transmission. The VLAN must be defined
beforehand on the VLAN configuration page.
Line Interface – IP Leased Line Standard (2)
▪
LAN INTERFACE: Define which IP address of the
device is to be used for the audio transmission.
▪
REMOTE GPIO MODE: When connected to a MAGIC
AC1 XIP, MAGIC ACip3 or MAGIC AC1 Go, the
states of the GPIO inputs can be transmitted to
the remote device. Specify how the data is
transmitted:
OFF: No transmission.
▪
▪
RTP (AVT CODECS ONLY): The states of the inputs
are transmitted in the RTP data stream.
PAD (AVT CODECS ONLY): The states of the inputs
▪
are fed into the coding algorithm as PAD. This is
only supported with MPEG.
AUTO CONNECT AFTER POWER UP: Audio
▪
transmission starts automatically after the device
has been powered up.
Advertisement
Table of Contents
