Din Rail Mounting - Emerson FBxEdge User Manual

A.5.2

DIN Rail Mounting

Depending on the size of the DIN rail connector, use either of the two DIN rail mounting
options:
If the DIN connector is 7.5 mm in height, use a single DIN rail support to offset the

bottom of the gateway
If the DIN connector is 15 mm in height, use two DIN rail supports in a stack to

increase the height to offset the bottom of the gateway.
To connect the gateway to a DIN rail, first connect the DIN Rail Clamp #R2B00ACCRM01 to
the rear of the gateway:
1. Place the DIN rail on the rear face of the gateway.
2. Use a T9 Torx
tightening to 0.6 Nm (do not overtighten). In rugged applications, use a thread-
locking compound to prevent the screws from loosening.
Figure A-11. Attaching a DIN Rail to the Gateway
Installing the RXi2-BP Gateway
driver to secure the DIN rail with the provided M3x5-A2 screws,
®
Emerson FBxEdge User Guide
D301913X012
October 2023
A-9