Troubleshooting - Futurecom PDR8000 Programming Manual

Troubleshooting

Errors/Warnings may be caused due to any or all of the following reasons:
•
Improper PDR8000 Programming.
•
PDR8000 Firmware upgrade is improperly done.
(Make sure the PDR8000 is on the current released Firmware available on the Futurecom
website.)
PDR8000 LED Status on the Display Panel
BLUETOOTH
LOCAL RPT
DC/BATTERY
PDR8000
Status
Power up Power & DC/Battery LED
Wireline LINK Tx/Rx LED
Enabled
Repeater Top left Fallback LED
Fallback Mode
2021-11-0
RESET
WLAN
LINK TX
LINK RX
LED
PDR8000® Portable Digital Repeater Programming Guide
PDR PTT
LINK QUALITY
LAN STATUS
RF TX
RF RX
PDR STATUS
POWER
LED Status
ON/OFF/Blinking
OFF
Blinking
ON
8K088X04 R5.00
General Status LEDs
Dedicated Status LEDs
Action
Disconnect the power source and
replace the appropriate fuse.
Check the Wireline connection
and PDR8000 Deployment
programming.
Check Deployment programming.
Page 91 of 98