Table of Contents
Advertisement
Assembly Hardware - Modular Connectors
Modular Connector (clip) and Shoulder Screw
• This connector offers a hidden connection between two panels.
• The modular connector and a connector screw are used in combination to
assemble panels.
• The modular connector is always pre-installed by the factory.
• The modular connector is always installed with the WIDE opening oriented at the
bottom of the part.
• The connecting shoulder screw is field installed, based on the application of
components.
Steps to install modular connectors:
STEP 1: Install connecting shoulder screws at the pre-drilled location as per configuration.
STEP 2: Line up shoulder screws to the modular connector in another component.
STEP 3: Push components together and push down to lock component in place, using
a rubber mallet, if necessary.
Assembly Hardware - Blum Connectors
STEP 1: Install Blum Connector screws into the pre-drilled holes.
STEP 2: Line Blum connector screws to the exposed Blum Connectors
STEP 3: On the bottom of the surface turn the screw on Blum Connector ¼ turn, do
not over tighten.
Assembly Hardware - Joint Conncetor
This type of connector is used to attach the extrusion to the 1" end gables.
Steps to install connectors:
STEP 1: Press nut connector into pre-drilled hole of end gable from the exterior side of
the end gable.
STEP 2: Push bolt into extrusion holes.
STEP 3: Screw the nut and bolt together.
globalfurnituregroup.com
Assembly Hardware - Handels, Elbow Catch
Elbow Catch
Install the elbow catch on the left hand door at the
upper right corner with the screws provided.
Joint Connector Bolt
Joint Connector Nut
LICENCE INSTALLATION
Modular Connector (clip)
Shoulder Screw
3
2
1
2
3
Door / Drawer Handle
Install the handle(s) in the predrilled holes on the
doors or drawers by using the screws provided.
1
CANADA
2
Advertisement
Table of Contents
