L2Ck - Global Licence 2 Installation Manual

L2CK

NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed area to assemble desk. This unit is best to as-
semble upside down.
STEP 3: Determine position of left and right gables as this will determine position of
hardware.
a. Partial gables, orient so that exposed holes are on the back edge. Install
levellers into T nuts, using mallet install into pre-drilled holes on the bottom
of gable. Install Blum connector screws on the top and back edge into pre-
drilled holes. Note that 2 holes are available in each position, install in hole
closest to underside of the desk.
b. Back panel one. Orient with Blum connectors facing inside of desk so
that exposed Blum connectors line up with partial gable. Install levellers
into T nuts, using mallet install into pre-drilled holes on the bottom of
gable. Install Blum connector screws on the top and side edge opposite
Blum connectors, into pre-drilled holes.
STEP 4: Connect chassis together by lining up Blum connectors with Blum connector
screws on adjoining pieces. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 5: Lay worksuface on floor with Blum connectors facing up. Install assembled
chassis by lining up Blum connector screws with the Blum connectors on the work-
surface top. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 6: Lay keyboard tray along front edge of main worksurface, space with 1" gap
between keyboard tray and main surface. Place keyboard mechanism in place, cen-
tering along centerline. Screw into main surface and key board surface using #8x3/4
wood screws provided.
Installation For Similar Products
L2CSKxxxxxx
globalfurnituregroup.com
Required Tools
Safety Glasses Screwdriver #2 Phillips
Included Hardware
Blum Connector Blum Connector
Screw L005650060 (installed) L005650061
Wood Screw #8 3/4 Connector Bolt
L007250032 L005650114
STEP 7: Stand completed assembly upright.
STEP 8: Using the provided #8 x ¾ wood screws, secure flat brackets to the underside
of adjoining surfaces. The half flat bracket is to be installed in the "cableway" opening
in the partial gable. Install full flat bracket half way between front edge of surface
and the front edge of the partial Gable.
gable of adjoining assembly using hex wrench.
LICENCE INSTALLATION
Screwdriver Roberson Rubber Mallet
Leveler "T" Nut Insert
L007240005 L007250039
Connector Nut Bracket
L005650117 L005651035
a. Connecter bolts and nuts will be used to gang narrow gable to partial
WORKSURFACE
BACK PANEL
NARROW GABLE
Hex Wrench
Flat Bracket
L005650025
BACK PANEL
NARROW GABLE
CANADA 52