Table of Contents
Advertisement
L2Bxxxx
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed are to assemble desk. It is advisable to do final
assembly upside down.
STEP 3: Modesty panel. Install Blum Connecter screws in pre-drilled holes on top
edge of the Modesty.
STEP 4: With the worksurface laying upside down on the floor, Pick up modesty lining
up Blum connecter screws to the Blum connectors installed on the bottom of the
surface. Tighten Blum connecter ¼ turn, do not over tighten.
STEP 5: Stand completed assembly upright and you are ready to install.
STEP 6: This unit is intended to be attached to adjoining assembled units on both
ends the provided Flat Brackets. The Flat Brackets are screwed into ganged assem-
blies at the worksurface joint using #8 x ¾ wood screws.
globalfurnituregroup.com
Back Panel
Required Tools
Safety Glasses
Screwdriver #2 Phillips
Included Hardware
Blum Connector
Blum Connector
(installed) L005650061
Screw L005650060
Back Panel
6
Top Underside
Back Panel
Top Underside
Back Panel
Top Underside
LICENCE INSTALLATION
Screwdriver #2 Roberson
Flat Bracket
Wood Screw #8 3/4
L005650025
L007250032
3
Back Panel
Top Underside
4
Rubber Mallet
WORKSURFACE
5
FULL MODESTY
CANADA
44
Advertisement
Table of Contents
