Table of Contents
Advertisement
L2B2Hxxxx • Bookcase
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assembly
of this product upright.
STEP 3: Lay bottom piece down with connecting cams facing up.
a. Lay baseboard along front edge (edge without quick fit cam). Space
baseboard with equal overhang on both sides and insure that the top edge
of baseboard and the top of bottom shelf are aligned. Using the Small "L"
bracket and #8 x ¾ wood screws, secure as shown.
STEP 4: Lay back panel on ground face up, insert connecting dowel in bottom
center pre-drilled hole.
a. Connect bottom assembly to the back board by lining up connecting
dowel to connecting cam as shown. Using screwdriver, turn connecting
cam to 2 O'clock position to secure.
STEP 5. Lay either left or right end panel on ground with exposed holes
for shelf adjustment facing up. Insert connecting dowels in pre-drilled
holes on perimeter.
a. Pick up assemble pieces and line up connecting dowels with connecting
cams. Using screwdriver, turn cam to 2 O'clock position to secure.
STEP 6: Repeat for opposite side.
STEP 7: On the bottom, install one large "L" bracket in each corner using #8 x ¾ woods
screws provided. Install levellers into T nut inserts, use mallet to install in pre-drilled
holes on left and right end panels
STEP 8: Stand assembly upright.
STEP 9: Install connecting dowels in pre-drilled holes on top edge of the end panels
and the back panel. Place top panel onto assembly lining up the connecting dowels
with the connecting cam. Using screwdriver, turn quick fit cam to 2 O'clock position
to secure.
STEP 10: Arrange shelf support pins as required and install shelves. Note that you
are able to secure shelves in place by screwing the shelf support pin to the underside
of the shelf after final positioning has been done.
Installation For Similar Products
L2B3Hxxxx
L2B4Hxxxx
globalfurnituregroup.com
Required Tools
Safety Glasses
Screwdriver #2 Phillips
Included Hardware
Connecting Dowel
Connecting Cam
L004250004
L007250002
Leveler
"T" Nut Insert
L007240005
L007250039
L2B5Hxxxx
LICENCE INSTALLATION
Screwdriver #2 Robertson
"L" Bracket
"L" Bracket
L005650065
L005650064
TOP
END PANEL
BACK BOARD
SHELF
BOTTOM
BASEBOARD
L2B6Hxxxx
Rubber Mallet
Shelf Support Pin
L007250013
END PANEL
CANADA
86
Advertisement
Table of Contents
