L2CRSHxxxx • L2 Credenza Shell Half Modesty
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assembly
of this product upside down.
STEP 3: Determine position of left and right gables with exposed Blum connectors
facing inside of assembly.
a. install levellers into the T nut inserts, install into pre-drilled holes on the
bottom of the gable using mallet.
b. On the top edge, install Blum Connector screws into the pre-drilled
holes. Since the Gables can be used either left or right, 2 holes are pre-
drilled, select the hole that is closest to underside of completed assembly
to ensure proper alignment.
STEP 4: Half modesty panel, install Blum Connector screws in pre-drilled holes on the
top edge and both sides. This panel will attach to single Blum connector on each side
only.
STEP 5: Connect gables to the modesty panel by lining up Blum connector screws
with the Blum connectors. Turn the screw on Blum Connector ¼ turn, do not over
tighten.
STEP 6: Place worksurface top face down on clean unobstructed area. Pick up chas-
sis assembly and line Blum connector screws to the exposed Blum Connectors on the
bottom of the surface. Turn the screw on Blum Connector ¼ turn, do not over tighten.
STEP 7: Turn product upright. When final position has been located, level the unit with
the levellers installed on both gables.
globalfurnituregroup.com
Required Tools
Safety Glasses
Screwdriver #2 Phillips
Included Hardware
Blum Connector
Blum Connector
Screw L005650060
(installed) L005650061
LICENCE INSTALLATION
Rubber Mallet
Leveler
"T" Nut Insert
L007240005
L007250039
WORKSURFACE
GABLE
Level
HALF MODESTY
GABLE
CANADA
30