Table of Contents
Advertisement
L2ECxxxxxxR
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed area to assemble desk. This unit is best to as-
semble upside down.
STEP 3: Determine position of left and right gables as this will determine position of
hardware.
a. Orient partial gable so that exposed holes are on back edge. Install levellers
into T nuts, using mallet install into pre-drilled holes on the bottom of gable.
Install Blum connector screws on the top and back edge into pre-drilled
holes. Note that 2 holes are available in each position, install in hole closest
to underside of the desk.
b. End gable connecting, orient with Blum connectors facing inside of desk
Install levellers into T nuts, using mallet install into pre-drilled holes on the
bottom of gable. Install Blum connector screws on the top and back edge
into pre-drilled holes. Note that 2 holes are available in each position, install
in hole closest to underside of the desk.
c. Full modesty panel. Install Blum connector screws on the top and back
edge into pre-drilled holes.
d. Full end gable, orient with Blum connectors facing inside of desk. Install
levellers into T nuts on bottom of gable. Install Blum connector screws on
the top and back edge into pre-drilled holes. Note that 2 holes are available
in each position, install in hole closest to underside of the desk.
STEP 4: Connect chassis together by lining up Blum connectors with Blum connector
screws on adjoining pieces. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 5: Lay worksuface on floor with Blum connectors facing up. Install assembled
chassis by lining up Blum connector screws with the Blum connectors on the work-
surface top. Tighten Blum connectors ¼ turn, do not over tighten.
Installation For Similar Products
L2ECxxxxxxL
L2ECxxxxxxR
globalfurnituregroup.com
Required Tools
Safety Glasses
Screwdriver #2 Phillips
Included Hardware
Blum Connector
Blum Connector
Screw L005650060
(installed) L005650061
Bracket
Connector Bolt
L005651035
L005650114
STEP 6: Stand completed assembly upright.
STEP 7: Using the provided #8 x ¾ wood screws, secure flat brackets to the underside
of adjoining surfaces. The half flat bracket is to be installed in the "cableway" opening
in the narrow gable. Install full flat bracket half way between front edge of surface
and the front edge of the half Gable.
L2ECxxxxxxL
LICENCE INSTALLATION
Screwdriver Roberson
Rubber Mallet
Leveler
"T" Nut Insert
L007240005
L007250039
Connector Nut
Wood Screw #8 3/4
L005650117
L007250032
a. Connecter nolt and nut will be used to gang narrow gable to narrow
gable of adjoining assembly using hex wrench.
WORKSURFACE
GABLE
NARROW GABLE
Hex Wrench
Flat Bracket
L005650025
FULL MODESTY
GABLE
CANADA
46
Advertisement
Table of Contents
