L2Chk - Global Licence 2 Installation Manual

L2CHK

NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed area to assemble desk. This unit is best to as-
semble upside down.
STEP 3: Determine position of left and right gables as this will determine position of
hardware.
a. Partial gables, orient so that exposed holes are on the back edge. Install
levellers into T nuts, install into pre-drilled holes on bottom of gable using a
mallet. Install Blum connector screws on the top and only top position on
back edge into pre-drilled holes. Note that 2 holes are available in each
position, install in hole closest to underside of the desk.
b. Back panel one. Orient with Blum connectors facing inside of desk so
that exposed Blum connectors line up with partial gable. Install levellers
into T , install into pre-drilled holes on bottom of gable using a mallet.
Install Blum connector screws on the top and side edge opposite Blum
connectors, into pre-drilled holes.
STEP 4: Connect chassis together by lining up Blum connectors with Blum connector
screws on adjoining pieces. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 5: Lay worksuface on floor with Blum connectors facing up. Install assembled
chassis by lining up Blum connector screws with the Blum connectors on the work-
surface top. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 6: Lay keyboard tray along front edge of main worksurface, space with 1" gap
between keyboard tray and main surface. Place keyboard mechanism in place, cen-
tering along centerline. Screw into main surface and key board surface using #8x3/4
wood screws provided.
Installation For Similar Products
L2CSHKxxxxxx
globalfurnituregroup.com
Required Tools
Safety Glasses Screwdriver #2 Phillips
Included Hardware
Blum Connector Blum Connector
Screw L005650060 (installed) L005650061
Wood Screw #8 3/4 Connector Bolt
L007250032 L005650114
STEP 7: Stand completed assembly upright.
STEP 8: Using the provided #8 x ¾ wood screws, secure flat brackets to the underside
of adjoining surfaces. The half flat bracket is to be installed in the "cableway" opening
in the partial gable. Install full flat bracket half way between front edge of surface
and the front edge of the partial Gable.
LICENCE INSTALLATION
Screwdriver Roberson
Leveler
L007240005
Connector Nut
L005650117
a. Connecter bolts and nuts will be used to gang partial gable to partial
gable of adjoining assembly using hex wrench.
WORKSURFACE
HALF BACK
NARROW GABLE
Rubber Mallet Hex Wrench
"T" Nut Insert Flat Bracket
L007250039 L005650025
Bracket
L005651035
HALF BACK
NARROW GABLE
CANADA 54