L2Gb - Global Licence 2 Installation Manual

L2GB

NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assembly
of this product upright.
STEP 3: Install levellers into T nuts, using mallet install into pre-drilled holes on the
bottom of gable. Orient the gables as left and right with exposed drill holes on back
edge facing back.
Install Blum Connector screws into pre-drilled holes on back edge closest to under-
side of desk assembly.
a. install Blum Connector Screws on top edge of partial gables into pre-
drilled holes closest to underside of desk assembly.
STEP 4: On the worksurface, install Blum Connector screws in pre-drilled holes on the
back edge.
STEP 5: Lay worksurface bottom side up on clean unobstructed surface with Blum
Connectors facing up.
Install partial gables into Blum Connectors on the bottom of the surface. Insure that
the gables have Blum Connector screws facing underside of desk as configured in
step 3. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 5: Lay the back panel on clean unobstructed surface with Blum Connectors
facing up. On the bottom edge, Install levellers into T nuts, using mallet install into
pre-drilled holes.
STEP 6: Pick up assembly of the worksurface and end gables and line up Blum Con-
nector screws along the back end to the Blum connectors on the Back panel. Tighten
Blum Connector screws ¼ turn, do not over tighten. Stand Assembly upright.
STEP 7: This unit is intended to be attached to an adjoining assembled unit at both
ends using the provided Flat Brackets. The flat brackets are screwed into ganged
assemblies at the worksurface joint using #8 x ¾ wood screws
half flat bracket will be installed in "cableway" opening of partial gable.
a. Using Murikoshi Connector screw and ¼ - 2—2 Bolt, join half gables of
adjoin units though pre-drilled hole on the side of the gable.
globalfurnituregroup.com
Required Tools
Safety Glasses Screwdriver #2 Phillips
#4 & 5 Hex Wrench
Included Hardware
Blum Connector Blum Connector
Screw L005650060 (installed) L005650061
Connector Bolt Connector Nut
L005650114 L005650117
LICENCE INSTALLATION
Screwdriver Roberson Rubber Mallet
Flat Bracket Flat Bracket
L005650025 L005651035
Leveler "T" Nut Insert
L007240005
L007250039
WORKSURFACE
HALF GABLE
HALF GABLE
Level
Wood Screw #8 3/4
L007250032
BACK PANEL
CANADA 20