Table of Contents
Advertisement
LICENCE INSTALLATION
L2FDxxxxxx
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed area to assemble desk. This unit is best to as-
semble upside down.
STEP 3: Place worksurface face down on clean unobstructed work area.
STEP 4: Place full monolegs as per product evenly spaced leaving overhang based
on shape of worksurface top and 4 " from front and back edge. Secure using #8x3/4
wood screws to secure to the bottom of the surface.
STEP 5: Place small monolegs at straight end. These legs should be placed 4" from
both back and side edges. Secure using #8x3/4 wood screws to secure to the bottom
of the surface. The short legs are shipped with a 5/16 bolt installed into the bottom.
STEP 6: This product is shipped with a "HAT" channel support bar, install along
bottom of the surface. Please note that allow room to install Keyboard tray at users
edge if needed.
STEP 7: This product is intended to support from and be ganged to Licence 1 high
storage. To connect the small legs to Licence storage, Drill 3/8" through hole in base
storage and use bolt from inside storage to line up with nutsert in bottom of the short
leg.
Installation For Similar Products
L2FRxxxx
L2FAxxxxL
61
CANADA
Required Tools
Safety Glasses
Screwdriver #2 Robertson
Included Hardware
Wood Screw #8 3/4
L007250032
L2FPxxxxR
WORKSURFACE
LLSQ3X3
HAT CHANNEL
L2TCWxxxxL/R
Left Hand Shown
MONOLEGS
LLSQ3X3H28
globalfurnituregroup.com
Advertisement
Table of Contents
