L2Drxxxxfb - Global Licence 2 Installation Manual

L2DRxxxxFB

NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to as-
semble of this product upright.
STEP 3: Handles for pedestals are shipped installed on the inside of the cabinet.
Remove handle from the inside of the cabinet and re-install with the same screws on
the front of cabinet.
a. Levellers for pedestals are shipped inside the unit. These levellers should
be installed prior assembling complete unit.
6" REC MOD
92.2mm
96mm
102.7mm
Installation For Similar Products
L2DRxxxxBF L2DBxxxxFB
globalfurnituregroup.com
Required Tools
Safety Glasses Screwdriver #2 Phillips
Included Hardware
Blum Connector Blum Connector
Screw L005650060 (installed) L005650061
Leveler
L007240005
FLUSH MOD
HALF HEIGHT
MODESTY
FULL HEIGHT
MODESTY
9.5mm
162mm
L2DBxxxxBF
LICENCE INSTALLATION
Screwdriver Roberson
Modular Connector
(installed) L004250001
STEP 4: Arrange Pedestals as per the final configuration of the product.
a. Using a 1/8" drill bit, drill though holes into side of pedestal according to
the provided template on the side of the pedestal exposed to the underside
of the desk. For this application, use the half modesty and recessed panel location.
b. Modular screws are to be installed into these holes.
STEP 5: The modesty panel comes with Modular connectors installed on each end
of the panel.
On the top edge of the modesty panel, install Blum Connector screws into the pre-
drilled holes.
a. Attach the modesty panel to the pedestals by lining up modular con
nectors to screws installed on the pedestals, lift modesty and slide into
position ensuring to engage connectors to screws. You can use a mallet
to securely seat the modesty panel into position. Do this on both sides
STEP 6: To install the worksurface top.
The worksurface comes with Blum Connectors pre-installed on the bottom of the
surface. Lift worksurface over the assembly and line up Blum connectors to the
installed Blum connector screws on the back of the modesty panel. Turn the screw
on Blum Connector ¼ turn, do not over tighten.
a. You must also secure the worksurface top to the pedestals. Line up
the top flush to the side and front of the pedestals. Use #8 x 3/4 wood
screws provided, screw through the mounting bar on the pedestal to
secure the top. Note: Drawers need to be removed to access drilling location.
STEP 7: When final position has been located, level the unit with the levellers
installed on both pedestals.
Rubber Mallet Level
Modular Screw Wood Screw #8 3/4
L007250001 L007250032
FULL MODESTY
WORKSURFACE
FF PED
BBF PED
CANADA 6