Table of Contents
Advertisement
L2HHxxHxx • All Storage Hutches
General Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk.
STEP 3: Installation of Hutch on Base unit. There are pre-installed strips of double
sided Tape on the bottom of the Unit. Peel off protective cover and place unit onto
base as required.
* Placement of the hutch should be such that the side gables of the Hutch
Sliding Door Assembly
STEP 4: Layout Sliding Doors an clean unobstructed surface, orient top and bot-
tom of doors based on handle positions.
STEP 5: Bottom Casters and Top Glides are provided. Place Bottom Caster pieces
in cut-outs along bottom edge of both doors and screw into place with provided
screws. Do the same for the Top Glides.
a. Insure that the top glide is "retracted" using the slide adjustment.
STEP 6: Place the first door in back rear track engaging the bottom caster into
the track, tip door in and line up with upper rear track. Extend the top glide using
adjustment slide adjustment for each top glide.
a. Repeat for door on front track.
STEP 7: Install provided handles into pre-drilled hole positions on left and right.
globalfurnituregroup.com
Required Tools
Safety Glasses
Screwdriver #2 Phillips
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
*Hutches with Sliding doors are shipped assembled with Sliding doors uninstalled
6
LICENCE INSTALLATION
Screwdriver #2 Robertson
storage unit line up with the gables on the base unit. Off module installation
of storage hutches is not recommended.
5
Rubber Mallet
CANADA
84
Advertisement
Table of Contents
