L2Grxx - Global Licence 2 Installation Manual

L2GRxx

NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assembly
of this product upright.
STEP 3: Install provided levellers into T nut inserts on the bottom of both left and
right hand end panels as well as half gable. Install T nuts, using mallet install into
pre-drilled holes on the bottom of gable. On the back and top edge of the end panels,
install Blum connector screws in pre-drilled holes.
STEP 4: On the worksurface, install Blum Connector screws in pre-drilled holes on the
back and side edges.
STEP 5: Lay the back panel on clean unobstructed surface with Blum Connectors
facing up. On the bottom edge, install the levellers into the T nut inserts. On the top
edge, install Blum connector screws into pre-drilled holes.
a. To attach the half gable mid support, install 2 modular connector screws in the
holes provide along center line. The half gable will connect to the back panel by lining
up modular connectors to the connector screws and slide down to engage. A mallet
may be used to properly seat the half gable.
STEP 6: lay either left or right end panel on the ground with exposed Blum connectors
facing up. Connect the side of worksurface by lining up the Blum connector screws to
the Blum connectors. Tighten screws on Blum Connectors ¼ turn, do not over tighten.
a. with the assistance of another person, turn assembly upright and connect
opposite end panel by connecting Blum Connector screws.
STEP 7: Pick up assembly of the worksurface and end gables and line up Blum Con-
nector screws along the back end to the Blum connectors on the Back panel. Tighten
Blum Connector screws ¼ turn, Do not over tighten. Stand Assembly upright.
STEP 8: To install transaction top, line the Blum Connectors installed on the bottom
of the top and line up with Blum connecting screws installed on the top edges of the
assembly. Tighten Blum Connector screws ¼ turn, Do not over tighten.
STEP 9: When in final position, level the unit.
globalfurnituregroup.com
Required Tools
Safety Glasses Screwdriver #2 Phillips
Included Hardware
Blum Connector Blum Connector
Screw L005650060 (installed) L005650061
Leveler "T" Nut Insert
L007240005 L007250039
LICENCE INSTALLATION
Screwdriver Roberson Rubber Mallet
Modular Connector Modular Screw
(installed) L004250001 L007250001
TRANSACTION TOP
WORKSURFACE
HALF GABLE
Level
BACK PANEL
GABLE
CANADA 18