Table of Contents
Advertisement
L2CCxxxxxx
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assembly
of this product upright.
STEP 3: Determine position of left and right gables as this will determine position of
hardware.
a. Partial gables, orient so that exposed holes are on the back edge. Install
levellers into T nuts, use mallet to install into pre-drilled holes on the
bottom of gable. Install Blum connector screws on the top and only top
position on back edge into pre-drilled holes. Note that 2 holes are available
in each position, install in hole closest to underside of the desk.
b. Back panel one. Orient with Blum connectors facing inside of desk so
that exposed Blum connectors line up with partial gable. Install levellers
into T nuts, install into pre-drilled holes on bottom of gable using a mallet.
Install Blum connector screws on the top and side edge opposite Blum
connectors, into pre-drilled holes.
STEP 4: Connect chassis together by lining up Blum connectors with Blum connector
screws on adjoining pieces. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 5: Lay worksuface on floor with Blum connectors facing up. Install assembled
chassis by lining up Blum connector screws with the Blum connectors on the work-
surface top. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 6: Stand completed assembly upright.
STEP 7: Using the provided #8 x ¾ wood screws, secure flat brackets to the underside
of adjoining surfaces. The half flat bracket is to be installed in the "cableway" opening
in the partial gable. Install full flat bracket half way between front edge of surface
and the front edge of the partial Gable.
a. Connecter Bolts and nuts will be used to gang narrow gable to partial
gable of adjoining assembly using hex wrench.
Installation For Similar Products
L2CCHxxxxxx
globalfurnituregroup.com
Required Tools
Safety Glasses
Screwdriver #2 Phillips
Included Hardware
Blum Connector
Blum Connector
Screw L005650060
(installed) L005650061
Wood Screw #8 3/4
Connector Bolt
L007250032
L005650114
LICENCE INSTALLATION
Screwdriver Roberson
Rubber Mallet
Leveler
"T" Nut Insert
L007240005
L007250039
Connector Nut
Bracket
L005650117
L005651035
WORKSURFACE
HALF BACK
NARROW GABLE
Hex Wrench
Flat Bracket
L005650025
HALF
BACK
NARROW GABLE
CANADA
50
Advertisement
Table of Contents
