Table of Contents
Advertisement
LICENCE INSTALLATION
Wire Manager
The wire manager can be installed either after the unit has been inverted and in position,
or while the worksurface is upside down on the floor.
STEP 1: Orient the extruded PVC wire manager so the opening for the wires is facing the
back of the worksurface.
STEP 2: Align the wire manager with the metal inserts located in the worksurface. Install
the six supplied 1/4-20-2" bolts into the holes and secure.
Wire Management
Viceversa® tables have wire management built right into the leg to neatly organize electri-
cal and communication cables from the worksurface to the floor.
Leg
STEP 1: Remove the plastic wire management cover to expose channel.
STEP 2: Lay in power and telephone cable up along leg and secure in place by snapping
back in the plastic cover.
Horizontal wire management
STEP 3: Excess cables can also be neatly stored below the worksurface from any location
within the horizontal wire management tray . Wires may also be routed from table to table
along the wire management tray
Combination wire management
STEP 4: The Dogbone tables come standard with (2) grommets in the surface for wire
management. Cables can be routed through the grommets, across the horizontal wire
manager then down the leg into wall, floor or electrified panels.
81
CANADA
front of the worksurface
(chair side)
4
worksurface is
upside down on
the floor
2
1
2
1
plastic wire
management
3
back of the
worksurface
2
globalfurnituregroup.com
Advertisement
Table of Contents
