Table of Contents
Advertisement
L2ERH-L
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assembly
of this product upright.
STEP 3: Determine placement of the gable, the gable can be used as both left and right.
Base on the application orient gable with exposed Blum connectors to the back.
a. Install levellers into T nuts, using mallet install into pre-drilled holes on
the bottom of gable.
b. Installing the Blum Connecter Screws on top and back edge.
STEP 4: Modesty panel. Install Blum Connecter screws in pre-drilled holes on top
edge of the Modesty.
a. Install Blum connector screws on edge of modesty that lines up with the gable.
b. Connect gable to modesty panel to the gable by lining up connector
screws with the Blum Connectors. Tighten Blum connectors ¼ turn, do not
over tighten.
STEP 5: With the Worksurface laying upside down on the floor, Pick up chassis
assembly lining up Blum connecter screws to the Blum connectors installed on the
bottom of the surface. Tighten Blum connecter ¼ turn, do not over tighten.
STEP 6: Stand completed assembly upright and you are ready to install.
STEP 8. This unit is intended to be attached to an adjoining assembled unit at the
open end using the provided Flat Brackets. The Flat Brackets are screwed into
ganged assemblies at the worksurface joint using #8 x ¾ wood screws.
STEP 9: When final position has been located, level the unit with the levellers
installed on the pedestal.
Installation For Similar Products
L2ERHxxxxR
globalfurnituregroup.com
Required Tools
Safety Glasses
Screwdriver #2 Phillips
Included Hardware
Blum Connector
Blum Connector
Screw L005650060
(installed) L005650061
Flat Bracket
L005650025
LICENCE INSTALLATION
Screwdriver Roberson
Rubber Mallet
Wood Screw #8 3/4
Leveler
L007250032
L007240005
HALF MODESTY
WORKSURFACE
GABLE
Level
"T" Nut Insert
L007250039
CANADA
42
Advertisement
Table of Contents
