L2Cc - Global Licence 2 Installation Manual

L2CC

NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed area to assemble desk. This unit is best to as-
semble upside down.
STEP 3: Determine position of left and right gables as this will determine position of
hardware.
a. Partial gables, orient so that exposed holes are on the back edge Install
levellers into T nuts, using mallet install into pre-drilled holes on the bottom
of gable. Install Blum connector screws on the top and back edge into pre-
drilled holes. Note that 2 holes are available in each position, install in hole
closest to underside of the desk.
b. Back panel one. Orient with Blum connectors facing inside of desk so
that exposed Blum connecotrs line up with Narrow gable Install levellers
into T nuts, using mallet install into pre-drilled holes on the bottom of
gable. Install Blum connector screws on the top and side edge opposite
Blum connectors, into pre-drilled holes.
STEP 4: Connect chassis together by lining up Blum connectors with Blum connector
screws on adjoining pieces. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 5: Lay worksuface on floor with Blum connectors facing up. Install assembled
chassis by lining up Blum connector screws with the Blum connectors on the work-
surface top. Tighten Blum connectors ¼ turn, do not over tighten.
STEP 6: Stand completed assembly upright.
STEP 7: Using the provided #8 x ¾ wood screws, secure flat brackets to the underside
of adjoining surfaces. The half flat bracket is to be installed in the "cableway" opening
in the narrow gable. Install full flat bracket half way between front edge of surface
and the front edge of the half Gable.
a. Connecter bolts and nuts will be used to gang narrow gable to narrow
gable of adjoining assembly using hex wrench.
Installation For Similar Products
L2CSxxxxxx
globalfurnituregroup.com
Required Tools
Safety Glasses Screwdriver #2 Phillips
Included Hardware
Blum Connector Blum Connector
Screw L005650060 (installed) L005650061
Wood Screw #8 3/4 Connector Bolt
L007250032 L005650114
LICENCE INSTALLATION
Screwdriver Roberson
Leveler "T" Nut Insert
L007240005 L007250039
Connector Nut Flat Bracket
L005650117 L005651035
WORKSURFACE
GABLE
BACK PANEL
Rubber Mallet Hex Wrench
Flat Bracket
L005650025
GABLE
BACK PANEL
CANADA 48