L2Erh-Fl - Global Licence 2 Installation Manual

L2ERH-FL

NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware
STEP 2: Pick a clean unobstructed area to assemble desk. It is advisable to assembly
of this product upright.
STEP 3: Handles for Pedestals are Shipped Installed on the inside of the cabinet.
Remove handle from the inside of the cabinet and re-install with the same screws on
the front of cabinet.
a. Levellers for pedestals are shipped inside the unit. These levellers should
be installed prior assembling complete unit.
STEP 4: Arrange Pedestal and gable as per the final configuration of the product.
a. Using a 1/8" drill bit, drill though holes into side of pedestal according to
the provided template on the side of the pedestal exposed to the underside
of the desk. For this application, use the half modesty and flush panel location.
b. Modular screws are to be installed into these holes.
6" REC MOD
92.2mm
96mm
102.7mm
Installation For Similar Products
L2ERHxxxxFR L2ERHxxxxBL L2ERHxxxxBL
globalfurnituregroup.com
Required Tools
Safety Glasses Screwdriver #2 Phillips
Included Hardware
Blum Connector Blum Connector
Screw L005650060 (installed) L005650061
Flat Bracket Leveler
L005650025 L007240005
FLUSH MOD
HALF HEIGHT
MODESTY
FULL HEIGHT
MODESTY
9.5mm
162mm
L2ERxxxxBR
LICENCE INSTALLATION
Screwdriver Roberson
Modular Connector
(installed) L004250001
Wood Screw #8 3/4
L007250032
STEP 5: The modesty panel comes with Modular connectors installed to connect to
the Pedestal. On the top edge of the modesty panel, install Blum Connector screws
into the pre-drilled holes.
• There are 2 holes here, select hole closest to underside of assembly to
correctly line up with the Blum Connectors.
STEP 6: Attach the modesty panel to the pedestals by lining up modular connectors
to screws installed on the pedestal, lift modesty and slide into position ensuring to
engage connectors to screws. You can use a mallet to securely seat the modesty
panel into position.
STEP 7: To install the worksurface top. The worksurface comes with Blum Connec-
tors pre-installed on the bottom of the surface. Lift worksurface over the assembly
and line up Blum connectors to the installed Blum connector screws on the mod-
esty panel. Turn screw on Blum Connector ¼ turn, do not over tighten
a. You must also secure the worksurface top to the pedestal. Line up the
top flush to the side and front of the pedestal. Use #8 x 3/4 wood screws
provided, screw through the mounting bar on the pedestal to secure the
top. Note: Drawers need to be removed to access drilling location.
STEP 8: This unit is intended to be attached to an adjoining assembled unit at the
open end using the provided Flat Brackets. The Flat Brackets are screwed into
ganged assemblies at the worksurface joint using #8 x ¾ wood screws.
STEP 9: When final position has been located, level the unit with the levellers
installed on the pedestal.
WORKSURFACE
FF PED
Rubber Mallet Level
Modular Screw
L007250001
HALF MODESTY
CANADA 16