Table of Contents
Advertisement
L2TDxxxxxx
NOTE: Open and assemble only one product
at a time to avoid a potential mix-up of parts
and hardware.
It is adviseable to assemble the unit on a
carpet to avoid scratches.
Assembly
STEP 1: Unpack and inspect individual pieces for damages or missing hardware.
STEP 2: Pick a clean unobstructed area to assemble desk. This unit is best to as-
semble upside down.
STEP 3: Orient gable with pre-drilled Holes facing underside of the desk assembly.
a. Install levellers into T nuts, using mallet install into pre-drilled holes on
the bottom of gable.
b. Install Blum Connector screws into pre-drilled holes on the top edge of
the gable.
c. Based on the application, see drawing for positioning, install Modular
connector screws in the top and bottom pre-drilled hole positions.
STEP 4: Partial Gable Install levellers into T nuts, using mallet install into pre-drilled
holes on the bottom of gable. The half gable will have modular connectors pre-
installed on back edge.
STEP 5: Connect partial gable to the full gable by lining up modular connectors with
modular screws and slide half gable down, you can use a mallet to securely seat the
half gable into position.
STEP 6: Lay worksurface face down on clean surface, be sure to verify handedness.
Connect chassis by ling up Blum connector screws on the gables with Blum connec-
Installation For Similar Products
L2TAxxxx
L2TPxxxxL
L2TEDxxxxxxL
L2TEDxxxxxxR
globalfurnituregroup.com
Required Tools
Safety Glasses
Screwdriver #2 Phillips
Included Hardware
Blum Connector
Blum Connector
Screw L005650060
(installed) L005650061
Modular Connector
(installed) L004250001
Modular Screw
L007250001
tors on the bottom of the surface. Turn the screw on Blum Connector ¼ turn, do not
over tighten.
STEP 7: Install Monoleg, No pre-drilled holes are provided. Place monoleg along cen-
ter line, lining up with half gable, leaving equal distance from the end and the sides.
Screw into place with provided # 8 x ¾ wood screws.
STEP 8: Turn Assembly upright.
STEP 9: This product is intended to be ganged to adjoin surface. Using flat brackets,
secure with #8x3/4 wood screws to attach underside of surface to adjoin assembly.
L2TPxxxxR
L2TEDCOxxxxxxR
LICENCE INSTALLATION
Screwdriver #2 Robertson
Leveler
"T" Nut Insert
L007240005
L007250039
Wood Screw #8 3/4
L007250032
WORKSURFACE
END GABLE
NARROW GABLE
L2THxxxxxxL
L2THxxxxxxR
L2TEDCOxxxxxxL
Rubber Mallet
Flat Bracket
L005650025
MONOLEG
L2BHML03 (default)
or
L2LSQ3X3
CANADA
58
Advertisement
Table of Contents
