Table of Contents
Advertisement
2.5.
CONFIGURING THE BASIC NETWORK SETTINGS
Select option (1) Network Configuration, the Network Configuration menu will be displayed as shown in
Figure 2-5. If you prefer to use DHCP then you may select option (5) Use DHCP, and then continue
from step 4:
1. Select option (1) Set IP Address and configure the IP address for the 3480DEC18-MP2SD-
ASI18 ensuring that the IP address is not already in use on the network.
2. Now select option (2) Set Netmask and configure the correct subnet mask for your network.
3. If required also configure option (3) Set Gateway.
4. Exit from the Network Configuration menu using (s) Save and Exit, NOT (x) Exit.
From the Main Menu select option (2) SNMP Configuration. Normally it is only necessary to configure
option (1) Set IP Address, and enter here the IP address of your VLPro Server. Exit using option (S)
Save and Exit. Now extract the card from the rack, remove the serial cable and re-insert it.
You have now completed the necessary minimum configuration and can connect the cables to the rear
of the card when ready.
Figure 2-5: Network Configuration Sub-Menu
Revision 0.1
3480DEC18-MP2SD-ASI18
High Density MPEG-2 SD Decoder
Page 7
Advertisement
Table of Contents
