The single Evertz encoder is on the receive side of the VBI Bridge. Starting with 8084 and 8084AD
firmware dated R010621, the receiving encoder can perform other captioning functions as well as re-
encode data as a VBI Bridge. This allows the user to insert new XDS, V-Chip, WebTV or other data,
and manipulate the re-insertion of the pre-existing data on a stream-by-stream basis.
The serial port on the Hubcap is fixed at 9600 baud, 8-bits data, 1 stop bit, no parity. The user must
ensure that the caption encoder is also configured to 9600 baud. Other serial port settings in the Evertz
encoder are changed automatically when the user selects CC Receive operation.
serial digital video
composite
encoder
SoftTouch MagHubcap
serial mode: extact raw field 1
or raw fields 1 & 2 data
Figure A-4: VBI Bridge using Evertz encoder and SoftTouch MagHubcap decoder
To configure the 8084 or 8084AD for VBI bridging in this application perform the following steps.
Set the Encoder to CC Receive Operation (to re-insert caption data after DVE):
•
Enter Engineering Setup menu system by pressing SHIFT+SETUP
•
Press UP or DOWN arrows until display shows >PORT B FUNCTION
•
Press LEFT or RIGHT arrows until display shows Funct B CC recv
•
Press SELECT button. CC recv will now be flashing to indicate that this mode is selected.
•
Exit the Engineering Setup menu system by pressing SETUP
APPLICATION NOTE 2
Models 8084/8084AD/8085 Closed Caption Encoder Manual
Digital Video
Effects device
RS-232
(straight-through cable)
Revision 1.6.6
serial digital video
Evertz 8084 or 8084AD
Port B in "CC Receive" mode
AN2-5