Operating The Manual Bypass Relay - evertz 8084 Instruction Manual

)CHAR POSITION
Ch pos = +00
Ch pos = -12
Ch pos = +12
)SDI BYPASS
Bypass = off
Bypass = on
OPERATION
Models 8084/8084AD/8085 Closed Caption Encoder Manual
U.S. MPAA: N/A, G, PG, PG-13, R, NC17, X, Not Rated
U.S. TV-PG: None, TVY, TVY7, TVG, TVPG, TV14, TVMA, None
CDN English: Exempt, C, C8+, G, PG, 14+, 18+
CDN French: Exempt, G, 8+, 13+, 16+, 18+
OTHER: oth0, oth1, oth2, oth3, oth4, oth5, oth6, oth7
For the U.S. TV Parental Guidance rating system, the decoder
display will also show the states of the (F)V, S, L and D bits.
CHAR POSITION
decoder display on the screen. Press the
current position. Use the
and press the SELECT key to save the new position.
Ch pos = +00 is the default position
Ch pos = +12 is the leftmost position
Ch pos = -12 is the rightmost position
On models equipped with a button marked DECODER, these menus are
unavailable. Instead, hold down DECODER and press the
shift the display left or right. Hold down DECODER and press the
keys to change the decoder channel. The front panel display will change
briefly to indicate which data channel (stream) is presently being
monitored. This allows easy configuration of the monitoring decoder
without entering the menu system.
The model 8084AD Closed Caption Decoder has two caption decoders,
one for monitoring the serial digital video stream and one for monitoring the
composite analog video stream. Both decoders are configured identically
by the operator controls.
3.2.5

Operating the Manual Bypass Relay

BYPASS RELAY is used to control the video bypass relay. This relay
automatically engages on power failure and directly connects
the VIDEO IN connectors to the BYPASS OUT connectors,
effectively bypassing all processing circuitry. The relay can also
be forced into bypass from the Bypass Relay Enable parallel
port control pin. (See section 3.5.1)
Select Bypass=off to configure the encoder for normal
operation.
Select Bypass=on to configure the encoder to be bypassed.
When the video is bypassed, no video will be routed through the video
processing circuitry. Consequently the COMPOSITE DECODER, SDI
PREVIEW and ANALOG PREVIEW outputs will not be active.
is used to adjust the horizontal position of the
and
Revision 1.6.6
key to view the
keys to change the position
or keys to
or
Page 3-14