Table of Contents
Advertisement
7700 MultiFrame Manual
7700SID(-AM) Source Identification Decoder
5.2.
NAVIGATING THE ON SCREEN DISPLAY MENUS
The three position, return to center, toggle switch and momentary push button located on the front edge of
the module is used to navigate the on screen display (OSD) setup menus and configure the cards various
controls.
To enter the OSD menu system, press the push button once. This will bring you to the main setup menu
where you can use the toggle switch to move up and down the list of available sub menus. An arrow
moves up and down the left hand side of the menu items to indicate which item you are currently
choosing. Once the arrow is on the desired item, press the push button to select the next menu.
On all menus, there are two extra selectable items; BACK and EXIT. Selecting BACK will take you to the
previous menu (the one that was used to get into the menu) while EXIT will return the display to its normal
operating mode. On the main menu, BACK and EXIT will both take you to the normal operating mode.
Once in a sub menu, there may be another menu layer, or there may be a list of parameters to adjust. If
there is another set of menu choices, use the toggle switch to select the next choice with the same
procedure as in the main menu.
To adjust any parameter, use the toggle switch to move up or down to the desired parameter and press
the push button. The arrow will move to the end of the line (right hand side) indicating that you can now
adjust the parameter. Using the toggle switch, adjust the parameter to its desired value. If the parameter is
a numerical value, the number will increase if you lift the toggle switch and decrease if you push down on
the toggle switch. It the parameter contains a list of choices, you can cycle through the list by pressing the
toggle switch in either direction.
When you have stopped at the desired value, depress the push button. This will update the parameter with
the selected value and move the arrow back to the left side of the parameter list. Continue selecting and
adjusting other parameters or use the BACK or EXIT commands.
7700SID(-AM)-9
Revision 0.3
Advertisement
Table of Contents
