Table of Contents
Advertisement
SERIAL PROTOCOL
Models 8084/8084AD/8085 Closed Caption Encoder Manual
The parameter o/h identifies whether the article should be placed into the
output queue or whether it should just be held in memory for later use.
The parameter n/l identifies whether the article should be placed as the
first article in the output queue or the last article in the queue.
All subsequent data is part of the article until ^C is received. The encoder
will respond to each line of the article with a '>' prompt while the article is
being defined.
Examples:
^A0<sp>Test<sp>T1<sp>5<cr>
This is the first line<cr>
and this is the last line ^C
4.5.2 Output Article
This command allows the user to put an existing article (defined by the
Input article command) into the output queue of the specified text data
channels. An article may be put into an output queue more than once.
Command:
^A1<sp>name<sp>tc<sp>rc<sp>k/d<sp>o/h<sp>n/l<cr>
Default
tc:
last text channel the article was sent to
rc
current repeat count
k/d
last keep/delete status specified for the article
o/h
O
n/l
last next/last status specified for the article
The parameters have the same meaning as for the Input article command.
If the o/h parameter is H then this command may be used to change other
attributes of the article without outputting it.
The parameter name specifies the name of a previously defined article.
If the parameter k/d is D, and the article is currently being output, it will not
be removed until it has been completely output.
Examples:
^A1<sp>Test<sp>T2<sp>5<sp>D<cr>
Revision 1.6.6
A two line article called 'Test" which
will be placed at the end of the Text
1 output queue. The article will be
deleted after it is output 5 times.
The article called 'Test" will be
placed at the end of the Text 2
output queue.
The article will be
deleted after it is output 5 times.
Page 4-17
Advertisement
Table of Contents
