Reset Encoder - evertz 8083XDS-AD Instruction Manual

SERIAL PROTOCOL
8083XDS-AD Analog and SD-SDI XDS Encoder
Command: ^AI<sp>pn<sp>baud<sp>ws<sp>par<cr>
or ^AI<cr>
Default: none
The parameter baud specifies the baud rate that will be used.
permitted values of parameter baud are shown in the table below.
Parameter Baud rate
12 1200
1200 1200
24 2400
2400 2400
48 4800
4800 4800
96 9600
9600 9600
192 19200
19200 19200
384 38400
If the optional port name parameter is missing, then the current control port
will be assumed. If no parameters are specified, the 8083XDS-AD will
respond with a report of the communication parameters of all the comm
ports as shown below.
Port A: 1200 7 Odd
Port B: 9600 8 None
Port C: 1200 7 Odd
Port D: 4800 8 None
Examples: ^AI<sp>19200<cr>
^AI<sp>P1<sp>96<sp>8<sp>N Sets Port A to 9600,8,N
4.3.2

Reset Encoder

This command immediately clears the input and output data queues and
resets the 8083XDS-AD to the Transparent State in Field 1 and Field 2.
Article and XDS output queues are not reset by this command. They must
be explicitly reset by using the queue articles and queue XDS commands.
(See sections 4.5.4 and 4.6.3.)
simultaneously sending data, this command only affects the fields and data
types that have not been appropriated by other control ports.
Command: ^F^F<cr>
Default: none
Revision 1.0.2
Set baud rate to 19200
Because other control ports may be
The
Page 4-7