Reset Encoder; Set Output Line - evertz MIO-CCE-4K/3G User Manual

MIO–CCE–4K/3G
SMPTE ST 2110/4K/3G/HD/SD Closed Caption Encoder with Media–to–IP Streaming
Command:
^AI<sp>pn<sp>baud<sp>ws<sp>par<cr>
or ^AI<cr>
Default: none
The parameter baud specifies the baud rate that will be used. The permitted values of parameter baud are
shown in the table below.
If the optional port name parameter is missing, then the current control port will be assumed. If no
parameters are specified, the MIO–CCE–4K/3G will respond with a report of the communication parameters
of all the COMM ports as shown below.
Port A:
Port B:
Port C:
Port D:
Examples:
^AI<sp>19200<cr>
^AI<sp>P1<sp>96<sp>8<sp>N
5.3.2.

Reset Encoder

This command immediately clears the input and output data queues and resets the MIO–CCE–4K/3G to
the Transparent State in Field 1 and Field 2. Article and XDS output queues are not reset by this command.
They must be explicitly reset by using the queue articles and queue XDS commands. (See sections 6.4.4
and 6.5.3.) To reset only a particular communications port, refer to the Reset Port (^Ar) command in section
6.6.5.
Command: ^F^F<cr>
Default: none
5.3.3.

Set Output Line

The normal line for caption information is line 21 in SD-SDI. This command allows the MIO–CCE–4K/3G
to output caption information on different line numbers. This command also changes the line number used
by the decoder.
Page - 54
Parameter Baud Rate
12
1200
1200 1200
24 2400
2400
2400
48
4800
4800 4800
96 9600
9600
9600
192 19200
19200 19200
384
38400
576
57600
1200 7 Odd
9600 8 None
1200 7 Odd
4800 8 None
Revision 1.0
Set baud rate to 19200
Sets Port A to 9600,8,N