Table of Contents
Advertisement
8083XDS-AD Analog and SD-SDI XDS Encoder
5.3
SERVICING INSTRUCTIONS
Page 5-2
Freq. Response:
Differential Gain:
Differential Phase: < 0.2 deg. up to 5 MHz
SNR:
Input-Output Delay: < 100 ns
Chroma-Luma Gain: < 0.4% up to 5 MHz
Chroma-Luma Delay: < 5ns up to 5 MHz
Line-Time Distortion: < 0.5%
Tilt:
5.2.5
Electrical
Voltage:
Fuse Rating:
Power:
Safety:
EMI/RFI:
A composite monitoring output with built-in caption decoder is provided.
This is an economical method of verifying the correct insertion of the
captioning data. This is described in more detail in section 5.4.2. Refer to
section 3.2.4 for instructions on configuring the caption decoder from the
front panel.
The front panel is used to configure various items through two menu
structures, the Setup menu and the Engineering menu. (See section 3.2
and 3.3 for a complete description of the menus). The front panel also
provides helpful diagnostic information at a glance, using the alphanumeric
display and indicator LEDs.
CAUTION – These servicing instructions are for use by qualified service
personnel only. To reduce risk of electric shock do not perform any
servicing instructions in this section of the manual unless you are
qualified to do so.
CAUTION – If the unit is fitted with dual power supplies, make sure that
power is removed from both supplies before performing any work on
the unit.
Revision 1.0.2
±0.15 dB up to 5 MHz
< 0.6% up to 5 MHz
> 75 dB
(blk field, 100 kHz to 5 MHz, unweighted)
RMS
< 0.5%
110 - 230 Volts AC, 50/60 Hz
– unit auto senses input voltage
250 V, 1 amp, time delay
30 VA
ETL Listed, complies with EU safety directives
Complies with FCC Part 15 Class A regulations
Complies with EU EMC directive
TECHNICAL DESCRIPTION
Advertisement
Table of Contents
