Table of Contents
Advertisement
TROUBLESHOOTING
8083XDS-AD Analog and SD-SDI XDS Encoder
computer was connected to Port B or Port C on the encoder, one may
simply disconnect the cable from the rear of the Evertz unit and connect to
a computer's COM port. For Port A, some rewiring may be required
depending on the system configuration.
Use a commercial "terminal" communications program to save a capture
file of the data coming from the captioning computer. Note that
some of the characters that are sent to the XDS encoder are not
standard printable ASCII characters. If your terminal program
supports any of these features, turn them OFF before saving
your capture file:
Strip high-bit of incoming characters
Mask non-ASCII characters
Any translation tables (such as V T-100 or ANSI)
Store only printable characters in capture file.
The following terminal programs are known to save useable capture files:
Telix 3.21 for DOS
Revision 1.0.2
Page 6-7
Advertisement
Table of Contents
