Table of Contents
Advertisement
5 HG1P
5.5 Specifications
The following specifications are when the HG1P optional cable, specified by IDEC, is attached.
■
Applicable Standards
Safety Standards
*1
EMC Standards
Environmental Specifications
■
Ambient Operating Temperature
Ambient Operating Humidity
Ambient Storage Temperature
Ambient Storage Humidity
Altitude
Pollution Degree
Corrosion Immunity
■
Electrical Specifications
Rated Voltage
Power Consumption
Not using USB Interface (USB2)
Power Voltage Range
Allowable Momentary Power Interruption
Inrush Current
Dielectric Withstand Voltage
■
Construction Specifications
Vibration Resistance
Shock Resistance
Dropping
Connector Insertion Life
When using the HG1P-ST32ZBFH-B0 with Connect Speed of 10/100 Mbps as the EMC Standard Approved
*1
Products, attach the recommended ferrite cores (2 pieces) near the connector for HG1P of the HG1P optional cable,
and fasten them to the cable with the clamp bands.
Connector for HG1P
1-82
UL61010-, UL61010-2-201
CSA C22.2 No.61010-1 (c-UL), CSA C22.2 No.61010-2-201 (c-UL)
IEC/EN 61131-2
FCC
0 to +45°C (no freezing)
10 to 90% RH (no condensation)
-10 to +60°C (no freezing)
10 to 90% RH (no condensation)
Up to 2000m (RUN)
750 to 1060hPa
2
Free from corrosive gases
24V DC
3W maximum
2W maximum
20.4 to 28.8V DC
10 ms maximum
20A maximum
AC500V, 10mA, 1 minute (between power and ground terminals)
5 to 8.4Hz amplitude 3.5mm,
8.4 to 150Hz acceleration 9.8m/s
1 octave 10 minutes
10 times on each of three mutually perpendicular axes (100 minutes)
(IEC 61131-2)
2
147m/s
, 11ms (5 shocks on each of three mutually perpendicular axes)
(IEC 61131-2)
1.5 m, 6 directions, 1 time
HG1P Optional Cable: 100 times
USB1: 5000 times
USB2: 1500 times
Recommended ferrite core: E04SR211132 (2 pcs) manufactured
Clamp Band
MICRO/I Hardware Manual
2
by SEIWA ELECTRIC MFG Corporation
Advertisement
Table of Contents
