IDEC MICRO/I HG2J-7U Hardware Manual page 4

Revision history
HG2J-7U:
• This product uses "PS2" as DC power supply. (based on the IEC/EN 61131 rating)
• Use wire of a proper size to meet the voltage and current requirements.
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F/-5T, HG1G:
• This product "PS2" as DC power supply. (based on the IEC/EN 61131 rating)
• Use wire of a proper size to meet the voltage and current requirements, and tighten the terminal screws of this
product to the specified tightening torque.
HG5G/4G/3G/2G-V, HG4G/3G, HG2G-5F:
• Be sure to confirm that the SD Memory Card Access lamp is not lit prior to turning the power off to this product
or pulling out the SD memory card. Refer to this manual for details.
HG1P:
• Use the HG1P optional cable for proper wiring.
• The D-sub connector on the end of the HG1P optional cable is not water- or dust-proof. If protection against
water and dust is required, the user must replace the D-sub connector with a water-proof connector.
Revision history
September 2023:
Caution
• All rights in this manual belong to IDEC Corporation. It may not be reproduced, reprinted, sold, transferred or
rented without our permission.
• The contents of this manual are subject to change without notice.
• Please contact your vendor or IDEC Corporation with any problems regarding the operation of this product.
Trademarks
WindO/I and MICRO/I are registered trademarks of IDEC CORPORATION in JAPAN.
All other company names and product names used in this manual are trademarks of their respective owners.
Preface-3
First Edition
MICRO/I Hardware Manual