Table of Contents
Advertisement
1 HG2J-7U
Installation
●
• Make a panel cut-out on the panel with the dimensions shown below.
B
A
• Use the attached mounting clips to tighten the screws evenly to mount panel: screws must be applied on total of
four places with the specified torque 0.5 to 0.6N∙m.
Panel
• Mount the main unit on a rigid panel.
• Do not tighten with excessive force, otherwise the main unit may warp the display, or impair the waterproof
characteristics.
• If the mounting clips are tightened obliquely to the panel, the main unit may fall off the panel.
• When installing the main unit into a panel cut-out, make sure that the gasket is not twisted. Especially when re-
installing, take special care because any twists in the gasket will impair the waterproof characteristics. Also, if
the gasket comes off the main unit, align the convex part of the gasket with the concave part of the front case,
and then insert the gasket fully into the gasket mounting groove without twisting it.
1-10
Unit: mm
A
B
+1.0
+1.0
118.6
176.6
0
Mounting Clip
Mounting Clip
MICRO/I Hardware Manual
Panel Thickness
1.0 to 5.0
0
Advertisement
Table of Contents
