Table of Contents
Advertisement
3 HG4G/3G, HG2G-5F
• Use the attached mounting clips to tighten the screws evenly to mount panel: screws must be applied on total of
four places on top and bottom with the specified torque. If mounting clips are attached in the part besides the
following figure, there is a risk of not satisfying product specifications such as waterproof performance, shock
resistance, and vibration resistance performance.
Mounting Clip Position
Example: HG3G-8 (8.4 inch)
TOP
BOTTOM
• Do not tighten with excessive force, otherwise the main unit may warp and cause wrinkle on the display, or
impair the waterproof characteristics.
• If the mounting clips are tightened obliquely to the panel, the main unit may fall off the panel.
• When installing the main unit into a panel cut-out, make sure that the gasket is not twisted. Especially when re-
installing, take special care because any twists in the gasket will impair the waterproof characteristics. Also, if
the gasket comes off the main unit, align the convex part of the gasket with the concave part of the front case,
and then insert the gasket fully into the gasket mounting groove without twisting it.
1-52
Mounting
Panel
Clip
MICRO/I Hardware Manual
Unit : N∙m
Model
Specified Torque
HG4G
0.5 to 0.6
HG3G-A
0.5 to 0.6
HG3G-8
0.5 to 0.6
HG2G-5F
0.2 to 0.3
Advertisement
Table of Contents
