IDEC MICRO/I HG2J-7U Hardware Manual page 69

Adjusting the Touch Panel
●
A gap may be caused in the operation accuracy of the touch panel by the secular distortion, etc. Adjust the touch
panel according to the following procedure when there is a gap in the operation of the touch panel.
1
Press the Main Menu on the Top Page in System Mode. The Main Menu Screen appears.
IDEC HG G SERIES
SYSTEM MODE TOP PAGE
Run Offline Main Menu
MAC Address 00:03:7B:F0:12:A8
IP Address 192.168.0.1(DHCP)
2010/OCT/14/THU 14:56:44
ENG/JPN
BRIGHTNESS 31
2
Press in order of Initial Setting, Initialize, Touch Panel Adjust. The confirmation screen appears and asks
"Adjust Touch Panel setting?". Press Yes, then the Touch Panel Adjust screen appears.
3
Press the center of the X mark, then the position of the mark changes one after another. Press five marks
sequentially.
Press the center of the X mark.
This will ensure the accuracy of the touch panel operation.
4
When normally recognized, the confirmation screen of
3
At procedure , when pressing a point away from the center of the X mark, a recognition error will result. Then the X
mark returns to the initial position, then repeat the procedure of
2
is restored.
3 again.
MICRO/I Hardware Manual
3 HG4G/3G, HG2G-5F
1
1-59