Table of Contents
Advertisement
Turn the shaded portion of the connector clockwise 90°.
5
Before locking the connector
The connector will stop turning at 90°. Do not try to turn it past 90°.
Removing and Installing the USB Port Cover
• When attaching the cover, tighten the screw to the recommended tightening torque (0.6 N·m).
• When installing the HG1P, make sure that the gasket is not twisted. Because any twisting in the gasket will
impair the waterproof characteristics.
■
Removing the USB Port Cover
Unscrew the USB port cover screw with a Phillips screwdriver, and then pull the USB port cover outward to open it.
USB Port Cover
Only one side of the USB port cover opens.
Be careful when opening the USB port cover because the part that opens may be damaged if excessive force
is used.
Do not remove the USB port cover screw from the USB port cover.
■
Installing the USB Port Cover
Close the USB port cover while pressing it with your finger, and tighten the USB port cover screw to recommend
tightening torque while keeping it from lifting up from the main unit.
Press with your finger
After locking the connector
USB Port Cover Screw
Phillips Screwdriver
MICRO/I Hardware Manual
5 HG1P
1
1-91
Advertisement
Table of Contents
