Table of Contents
Advertisement
2.10 Maintenance and Inspection
Maintain and inspect the HG5G/4G/3G/2G-V periodically to ensure the best performance. Do not disassemble, repair,
or modify the HG5G/4G/3G/2G-V during inspection.
Maintenance and
Inspection Parts
Display
Terminals, Connectors
Mounting Clips
Backlight
Backup Battery
Touch Panel
Replacing the Backup Battery
●
A backup battery is built into the HG5G/4G/3G/2G-V to retain the internal backup data (log data, keep resister, and
keep relay) and clock data.
When the "Replace the battery" message is displayed, replace the backup battery by following the procedure below.
When the "Battery level LOW" message is displayed, replace the battery immediately; otherwise, the backup data and
clock data may be lost.
Whether or not to display the reminder message for battery replacement can be specified with the configuration
software. For details, refer to Chapter 4 "3.1 System Tab" in the WindO/I-NV4 User's Manual.
1
Remove the battery holder cover.
2
Turn on the power to the HG5G/4G/3G/2G-V, wait for approximately one minute, and then turn off the power again.
After turning off the power to the HG5G/4G/3G/2G-V in step
seconds to replace the battery without losing the backup data and clock data. However, it is recommended
that the backup data be transferred to flash memory as a precautionary measure. For the procedure to
transfer the data to flash memory, refer to Chapter 35 "Internal Devices" in the WindO/I-NV4 User's Manual.
If it is not necessary to save the data, step
3
Remove the battery from the battery holder.
4
Install a replacement battery into the battery holder. Ensure that the orientation of the battery is correct.
(+) side
Wipe any stain of the display using a soft cloth slightly dampened with neutral detergent or alcoholic
solvent. Do not use solvents such as thinner, ammonia, strong acid, and strong alkaline.
Check the terminals and connectors to make sure of no loose screws, incomplete insertion, or
disconnected lines.
Make sure that all mounting clips and screws are tightened sufficiently. If the mounting clips are
loose, tighten the screw to the specified torque.
The HG5G/4G/3G/2G-V's backlight cannot be replaced by the customer. When the backlight
needs to be replaced. Contact your vendor or IDEC Corporation.
The operating life of the internal battery is approximately five years. It is recommended to replace the
battery every five years even before the reminder message for battery replacement is displayed.
A gap may be caused in the operation accuracy of the touch panel by the secular distortion, etc.
Readjust the touch panel in the System Mode according to the following procedure when there is
a gap in the operation of the touch panel.
for details.
2
MICRO/I Hardware Manual
Description
Refer to "Adjusting the Touch Panel" on page 1-38
2
, complete the steps through
can be skipped.
2 HG5G/4G/3G/2G-V
1
4
within 30
1-35
Advertisement
Table of Contents
