Table of Contents
Advertisement
5 HG1P
5.7 Installation
Operating Environment
●
• For designed performance and safety of the HG1P, do not install the HG1P in the following environments:
- Where dust, briny air, or iron powder exist.
- Where oil or chemical splashes for a long time.
- Where space is filled with oil mist.
- Where direct sunlight falls on the main unit.
- Where strong ultraviolet rays fall on the main unit.
- Where corrosive or combustible gasses exist.
- Where shocks or vibrations are transmitted.
- Where condensation occurs due to rapid temperature change.
- Where high-voltage or arc-generating equipment (electromagnetic contactors or circuit protectors) exists in close
proximity.
- Near devices that generate a lot of heat. Such as a boiler.
• Use the wall-mounted hook (optional item) for wall mounting.
Installation
●
Attaching the Optional Cable (HG9Z-XCP13/-XCP15/-XCP17) to the HG1P
• Make sure to turn off the HG1P's power before inserting or pulling the cable into or out of the connector.
• After locking the connector, gently tug on the cable to make sure that the connector does not come off.
• Do not apply an excessive tensile load to the cable, otherwise damage of the connector will result.
1
Turn the connector cap.
2
Pull off the connector cap.
1
2
Connector Cap
3
Turn the connector at the end of the HG1P optional cable to align the "open" text with the logo.
4
Align the connector at the end of the HG1P optional cable with the mating positioning mark, and then push it straight
on until the rubber (black) is completely covered.
Rubber (Black)
"open"
Logo
1-90
Mating Positioning Mark
4
3
MICRO/I Hardware Manual
Advertisement
Table of Contents
