IDEC MICRO/I HG2J-7U Hardware Manual page 86

4 HG2G-5T, HG1G
Handling of Batteries and Devices with Built-in Batteries in EU Member States
Note: The following symbol mark is for EU countries only and is according to the directive 2006/66/EC Article 20
information for end-users and Annex II.
This symbol mark means that batteries and accumulators, at their end-of life, should be disposed of separately from
your household waste.
If a chemical symbol is printed beneath the symbol shown above, this chemical symbol means that the battery or
accumulator contains a heavy metal at a certain concentration. This will be indicated as follows :
Hg : mercury (0.0005%), Cd : cadmium (0.002%), Pd : lead (0.004%)
In the European Union there are separate collection systems for used batteries and accumulators.
Please dispose of batteries and accumulators correctly in accordance with each country or local regulation.
Maintenance Screen
●
Turn on the power to the HG2G-5T, HG1G, then press and hold the touch panel on the upper-left corner of the screen
for three seconds or longer. The Maintenance Screen appears on the screen.
• Permission to show the Maintenance Screen can be set using the WindO/I-NV4. For details, refer to Chapter 4 "3.1
System Tab" in the WindO/I-NV4 User's Manual.
• The Maintenance Screen is not displayed in the System Mode.
System Mode
●
Press the System Mode at the top of the Maintenance Screen. The Top Page Screen appears.
SYSTEM MODE TOP PAGE
Run Offline
2010/OCT/14/THU 14:56:44
IP Address 192.168.0.1(DHCP)
<< BRIGHTNESS 16 BRIGHTNESS 16
Initial Setting, Self Diagnosis and Initialization of the data, etc can be executed in the System Mode.
1-76
Maintenance
System Mode
Device Monitor
Adjust Brightness
Maintenance Screen
Main Menu
>>
MICRO/I Hardware Manual