IDEC MICRO/I HG2J-7U Hardware Manual page 67

Table of Contents

Advertisement

5
With the new batter installed correctly, reverse the instruction the procedure described in item #1 above to secure the
cover.
• The operating life of the internal battery is approximately five years. It is recommended to replace the battery
every five years even before the reminder message for battery replacement is displayed.
• IDEC provides replacement service for the battery (at customer's expense). Contact your vendor or IDEC
Corporation.
The battery may be regulated by national or local regulation. Observe the instructions of proper regulation. As
electric capacity is left in a discarded battery and it comes into contact with other metals, it could lead to
distortion, leakage, overheating, or explosion, so make sure to cover the (+) and (-) terminals with insulating tape
before disposal.
When replacing the battery, use the specified battery only. Note that any problems and failures arising from or in
connection with the use of a battery other than the specified battery is not guaranteed.
Handling of Batteries and Devices with Built-in Batteries in EU Member States
Note: The following symbol mark is for EU countries only and is according to the directive 2006/66/EC Article 20
information for end-users and Annex II.
This symbol mark means that batteries and accumulators, at their end-of life, should be disposed of separately from
your household waste.
If a chemical symbol is printed beneath the symbol shown above, this chemical symbol means that the battery or
accumulator contains a heavy metal at a certain concentration. This will be indicated as follows :
Hg : mercury (0.0005%), Cd : cadmium (0.002%), Pd : lead (0.004%)
In the European Union there are separate collection systems for used batteries and accumulators.
Please dispose of batteries and accumulators correctly in accordance with each country or local regulation.
Maintenance Screen
Turn on the power to the HG4G/3G, HG2G-5F, then press and hold the touch panel on the upper-left corner of the
screen for three seconds or longer. The Maintenance Screen appears on the screen.
• Permission to show the Maintenance Screen can be set using the WindO/I-NV4. For details, refer to Chapter 4 "3.1
System Tab" in the WindO/I-NV4 User's Manual.
• The Maintenance Screen is not displayed in the System Mode.
Maintenance
System Mode
Device Monitor
Adjust Brightness
Maintenance Screen
MICRO/I Hardware Manual
3 HG4G/3G, HG2G-5F
1
1-57

Advertisement

Table of Contents
loading

Table of Contents