Maintenance And Inspection - IDEC MICRO/I HG2J-7U Hardware Manual

1 HG2J-7U

1.9 Maintenance and Inspection

Maintain and inspect the HG2J-7U periodically to ensure the best performance. Do not disassemble, repair, or modify
the HG2J-7U during inspection.
Maintenance and
Inspection Parts
Display
Terminals, Connectors
Mounting Clips
Backlight
Maintenance Screen
●
Turn on the power to the HG2J-7U, then press and hold the touch panel on the upper-left corner of the screen for
three seconds or longer. The Maintenance Screen appears on the screen.
• Permission to show the Maintenance Screen can be set using the WindO/I-NV4. For details, refer to Chapter 4 "3.1
System Tab" in the WindO/I-NV4 User's Manual.
• The Maintenance Screen is not displayed in the System Mode.
System Mode
●
Press the System Mode at the top of the Maintenance Screen. The Top Page Screen appears.
SYSTEM MODE TOP PAGE
Run Offline
MAC Address Invalid.
MAC Address 98:84:E3:8E:52:4B
IP Address 192.168.2.42(DHCP)
2021/JUN/29/TUE 08:57:36
SNTP EtherIP
BRIGHTNESS 31
<<
Initial Setting, Self Diagnosis and Initialization of the data, etc can be executed in the System Mode.
1-14
Wipe any stain of the display using a soft cloth slightly dampened with neutral detergent or
alcoholic solvent. Do not use solvents such as thinner, ammonia, strong acid, and strong alkaline.
Check the terminals and connectors to make sure of no loose screws, incomplete insertion, or
disconnected lines.
Make sure that all mounting clips and screws are tightened sufficiently. If the mounting clips are
loose, tighten the screw to the specified torque.
The HG2J-7U's backlight cannot be replaced by the customer. When the backlight needs to be
replaced. Contact your vendor or IDEC Corporation.
Maintenance
System Mode
Device Monitor
Adjust Brightness
Maintenance Screen
Main Menu
ENG/JPN
>>
MICRO/I Hardware Manual
Description