IDEC MICRO/I HG2J-7U Hardware Manual page 135

Analog Input Parameter Setting Values
The parameter setting values are as follows.
■ Signal Type
Setting Value
0 Unused
1 0 to 10V DC
2 -10 to +10V DC
3 0 to 20mA DC
4 4 to 20mA DC
5 Type K thermocouple
6 Type J thermocouple
7 Type R thermocouple
8 Type S thermocouple
9 Type B thermocouple
10 Type E thermocouple
11 Type T thermocouple
12 Type N thermocouple
13 Type C thermocouple
14 Pt100
15 Pt1000
16 Ni100
17 Ni1000
18 NTC Thermistor
19 PTC Thermistor
20 PTC Thermistor (threshold)
21 Ohm meter
22 Expansion 0 to 20mA DC
23 Expansion 4 to 20mA DC
If the setting value is outside the range, a parameter setting error will occur.
■ Data Format
Setting Value
0 Binary data, Binary data (12bit)
1 Optional range, Optional range (12bit)
2 Celsius (℃), Resistance (Ω), Binary data (16bit)
3 Fahrenheit (℉), Optional range (16bit)
If the setting value is 4 to 65,535, a parameter setting error will occur.
■ Min., Max.
The values of Min. and Max. can be set only when Data Format is set to Optional range. Set the minimum and
maximum values between -32,768 and 32,767. However, when Signal Type is set to PTC Thermistor (threshold),
set the values of Min. and Max. between 100 and 10,000.
Signal Type
Data Format
MICRO/I Hardware Manual
2 Analog I/O Modules
2
2-27