Table of Contents
Advertisement
324 Port InfiniBand FDR Switch Platform Hardware Installation Guide
2
Installing the Cable Holder
Step 1.
Step 2.
Step 3.
Step 4.
Mellanox Technologies
Now is the time to install the cable holder.
Figure 29: Cable Holder
Place the Cable holder next to the rack, on the connector side of the chassis,
and identify the holes where the caged nuts were placed.
The cable holders should go to the outside of the vertical supports.
Set the bottom of the cable holder at the level of the shelf.
Screw the cable holder onto the rack using the screws provided.
Repeat steps 1- 3 for the second cable holder.
Left side rack
Top side
10X M6 caged nut
10 X M6 bolt for caged
nut
Rev 1.0
33
Advertisement
Table of Contents
