Mellanox Technologies MSX6518-6R Hardware Installation Manual page 14

Rev 1.0
You will need a fork lift, to move and insert the chassis into the rack.
Use enough people to safely lift this product.
1.6.3.1 Requirements
You will need to have the following tools and equipment:
• #2 phillips screwdriver
• a fork lift
• measuring tape
The installation will be much easier with a power screwdriver.
It is recommended to use AWG6 or 4mm diameter wire for grounding purposes.
It is recommended to have at least two people for the duration of the installation proce-
dure. Use a mechanical lift to raise this chassis. If not, use enough manpower to ensure
the safety and wellbeing of all of the people involved in the installation.
1.6.3.2 Installation and Cable Management Kit Parts
• Parts included in the installation kit:
- 1 shelf with brackets pre-installed
- 1 left side upper bracket offset
- 2 lock down bars
- 8 lock washers for the upper brackets to
vertical support
- hex head bolts – 8 for the upper 
brackets and for the shelf extension
14
<40 lbs
40 - 70 lbs
<18 kgs
18 - 32 kgs
• #3 phillips screwdriver
• a grounding lug
• ground wire of sufficient length and gauge to properly ground the
chassis
70 - 121 lbs
32 - 55 kgs
- 1 shelf extension
- 1 right side upper bracket offset
- 2 upper bracket washers
- 12 lock washers for the upper brackets to
upper bracket offsets
- 20 caged nuts 12 for the shelf and 8 for the
chassis faceplate
Chassis Installation
>121 lbs
>55 kgs
Mellanox Technologies