Ground Connections; Installing The Cable Holder - Mellanox Technologies MTS3610 Installation Manual

MTS3610 Installation Guide

Ground Connections

Make sure to connect the ground post to a valid electrical ground. Use a grounding lug and a ground wire of
sufficient capacity to safely convey a potential discharge. The chassis is concurrently grounded through each
of the PSUs. Only connect the PSU cords to properly grounded outlets. Do not rely on the PSU grounds. It is
absolutely necessary to connect the grounding post. Make sure the connections are solid and permanent.
Grounding Grounding
post post

Installing the Cable Holder

Left side
rack
Top side
Holes for
connecting
the cable
holder to the
rack
Step 1. Place the Cable holder next to the rack and identify the holes for the caged nuts. The numbers
on the cable holders should face each other.
Step 2. Put the caged nuts into the previously identified holes in the rack.
Rev 1.2.2
Figure 10: Ground Connection
Mellanox Technologies
Grounding lug
X 8
X 8
Right side rack
Bottom side
7