Table of Contents
Advertisement
324 Port InfiniBand FDR Switch Platform Hardware Installation Guide
Table 6 - Configuration Wizard Session - Static IP Configuration
Mellanox configuration wizard
Do you want to use the wizard for initial configuration? y
Step 1: Hostname? [switch-112126]
Step 2: Use DHCP on mgmt0 interface? [yes] n
Step 3: Use zeroconf on mgmt0 interface? [no]
Step 4: Primary IP address? [for example 192.168.10.4]
Mask length may not be zero if address is not zero (interface eth0)
Step 5: Netmask? [0.0.0.0] 255.255.255.0
Step 6: Default gateway? [for example 192.168.10.1]
Step 7: Primary DNS server?
Step 8: Domain name?
Step 9: Enable IPv6? [yes] yes
Step 10: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no] no
Step 11: Admin password (Enter to leave unchanged)?
You have entered the following information:
1. Hostname: switch-112126
2. Use DHCP on mgmt0 interface: no
3. Use zeroconf on mgmt0 interface: no
4. Primary IP address: 192.168.10.4
5. Netmask: 255.255.255.0
6. Default gateway: 192.168.10.1
7. Primary DNS server:
8. Domain name:
9. Enable IPv6: yes
10.Enable IPv6 autoconfig (SLAAC) on mgmt0 interface: no
11.Admin password (Enter to leave unchanged): (unchanged)
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
Choice:
Configuration changes saved.
To return to the wizard from the CLI, enter the "configuration jump-start"
command from configure mode. Launching CLI...
switch-1
>
Step 5.
Mellanox Technologies
Wizard Session Display - Static IP Configuration (Example)
Before attempting a remote (for example, SSH) connection to the switch,
check the eth0 interface configuration. Specifically, verify the existence of an
IP address. To check the current eth0 configuration, enter the following com-
mands:
sx-43 [standalone: master] > enable
sx-43 [standalone: master] # show interfaces mgmt0
Rev 1.0
45
Advertisement
Table of Contents
