Table of Contents
Advertisement
38 Mechanical installation
Before installation
The drive must be installed in an upright position with the cooling section facing a
wall. Check the installation site according to the requirements below. Refer to
Dimensional drawings
WARNING! Do not remove the protective film that covers the unit before
the installation procedure is complete. It protects the unit from pieces of
wire cuttings or other solid particles that can penetrate the unit during
installation. Remove the film just before starting up the unit.
Requirements for the installation site
Technical data
See
(page 119) for the allowed operation conditions of the drive.
Wall
The wall should be as close to vertical as possible, of non-flammable material and
strong enough to carry the weight of the unit. Check that there is nothing on the wall
to inhibit the installation.
Floor
The floor/material below the installation should be non-flammable.
(page 137) for frame details.
Advertisement
Table of Contents
