Control Panel - ABB ACS800-31 Hardware Manual

104 Start-up and use
the line-side converter (ID number 2), the drive does not stop by pressing the
control panel Stop key in local control mode. Have the control panel control the
RMIO board of the motor-side converter in normal use.
•
Do not change the ID numbers of the converters from the default settings. If the
ID numbers of the line-side and motor side converters are set equal, the control
panel stops communicating.
•
Keep parameter 20.05 OVERVOLTAGE CTRL set to ON (default) when no brake
chopper and resistor are installed. The parameter index is valid for Standard
Control Program. For other control programs, see the appropriate firmware
manual. For parameter settings with a brake chopper and resistor, see
braking
(page 145).
Drives with option +Q950: Validate and do the start-up procedure of the Prevention
of unexpected start-up function according to instructions given in
AGPS board (Prevention of unexpected start-up, +Q950)
Drives with option +Q967: Validate and do the start-up procedure of the Safe torque
off function according to instructions given in
Safe torque off function (+Q967), Application guide

Control panel

The drive has a control panel (type CDP 312R). The CDP 312R is the user interface of
the line-side converter and the motor-side converter of the drive, providing the
essential controls such as Start/Stop/Direction/Reset/Reference, and the
parameter settings for the control programs. More information on using the control
panel can be found in the
The control panel is wired to both the line-side converter and the motor-side
converter using a Y-splitter. The converter that is currently being controlled is
indicated by the converter name on the drive display; the suffix "MR" denotes motor-
side converter, "LR" denotes line-side converter. The control is switched between the
converters as follows:
ACS800-01/04/11/31/104/104LC
Firmware Manual
delivered with the drive.
Installation of the
(page 83).
(3AUA0000063373 [English]).
Resistor