Table of Contents
Advertisement
18 Introduction to this manual
Categorization according to the plus code
The instructions, technical data and dimensional drawings that concern specific
optional selections are marked with + codes, for example, +E202. You can identify
the options in the drive from the + codes on the type designation label. The + code
selections are listed in
Contents
The chapters of this manual are briefly described below.
Safety instructions
commissioning, operation and maintenance of the drive.
Introduction to this manual
installing and commissioning the drive and refers to parts in this manual and other
manuals for particular tasks.
Operation principle and hardware description
Mechanical installation
Planning the electrical installation
selection, protections and cable routing.
Electrical installation
Installation of the AGPS board (Prevention of unexpected start-up, +Q950)
describes the electrical installation of the optional Prevention of unexpected start-
up function (+Q950).
Installation of the ASTO board (Safe torque off, +Q967)
electrical installation of the optional Safe torque off function (+Q967).
Motor control and I/O board (RMIO)
connections to the I/O board.
Installation checklist
electrical installation of the drive.
Start-up and use
(page 103) describes the start-up procedure and use of the drive.
Actual signals and parameters
the ACS800-31 and ACS800-U31.
Maintenance
(page 113) contains preventive maintenance instructions.
Fault tracing
(page 117) contains guidelines for fault tracing.
Technical data
(page 119) contains the technical specifications of the drive, for
example, the ratings, sizes and technical requirements and provisions for fulfilling
the requirements for CE and other markings.
Dimensional drawings
Resistor braking
(page 145) describes how to select, protect and wire external brake
choppers and resistors for the drive. The chapter also contains installation
instructions and the technical data.
External +24 V power supply for the RMIO boards via terminal X34
describes how to connect an external +24 V power supply for the RMIO board using
terminal X34.
Type code
(page 33).
(page 11) give safety instructions for the installation,
(page 17) lists the steps in checking the delivery and
(page 35) instructs in how to place and mount the drive.
(page 45) instructs in the motor and cable
(page 69) shows how to wire the drive.
(page 91) shows the external control
(page 99) contains a list for checking the mechanical and
(page 107) contains listings of parameters specific to
(page 137) contains the dimensional drawings of the drive.
(page 23) describes the drive.
(page 87) describes the
(page 83)
(page 149)
Advertisement
Table of Contents
